GBC Usp13 - Manual (Page 10)

USP 13 Universal Speed Punch
QUICK REFERENCE INSTRUCTIONS
1. DIE REPLACEMENT
BLOCK UP DIE WITH STICK PROVIDED
LOWER DIE
CLAMP STICK
REMOVE DIE CLAMPS - FRONT & REAR
REMOVE BOTTOM BOLTS
RELEASE CLAMP - RELAX PRESSURE WITH HAND WHEEL
SLIDE DIE OUT
REPLACE DIE WITH STICK IN PLACE
REPLACE BOTTOM BOLTS LOOSELY
ATTACH CLAMPS
TIGHTEN BOLTS
REMOVE STICK
LOWER RAM - TO ALIGN PUNCH PINS
TIGHTEN BOTTOM BOLTS
2. ADJUST BACK RAIL TO DIE BACK GAGE
3. SET PUNCHING DEPTH OF SHORTEST PIN
4. SET BACK JOGGER PULL UP JUST AS LONGEST PUNCH PIN APPEARS
5. SET FRONT STOP TO REAR JOGGER - FRONT STOP COMES TO
FULL UP JUST AS SIDE AND REAR JOGGER START TO MOVE
6. SET REGISTRATION WITH SAMPLE STOCK
7. LOCK FRONT STOP IN PLACE
8. SET SIDE JOGGER TO SLIGHTLY BUCKLE A SHEET OF PAPER.
SET OUTER BELT TO 1/4” OF FULLY JOGGED LIFT
9. SET UP TRANSPORT WHEELS AND BELTS
10. POSITION LONG SMALL ROLLER ASSEMBLY
11. ATTACH SKID STRAPS - END OF STRAPS 1” SHORT OF LEADING
EDGE OF LIFT
12. SET PUSHER SO THAT LEADING EDGE OF LIFT ARRIVES WITHIN
1” FROM FRONT STOP AS IT STOPS IN FULL UP POSITION
13. INSTALL DISKS. ALIGN DISKS WHEN CLAW IS AT 5 O’CLOCK
14. RETRACT KNIFE - LOAD PAPER - ALIGN MATERIAL WITH REAR GUIDE
15. INSTALL STACK GUIDES
16. SET FRONT GUIDE RAIL TO GUIDE LIFT INTO DIE
17. CHECK EVERYTHING FOR TIGHTNESS
18. MAKE FINAL ADJUSTMENT ON RECEIVING TRAY
19. CYCLE MACHINE AND CHECK RESULTS
8