GBC Usp13 User Manual

Page 8

Advertising
background image

111

170

83

127

1.0

Figure 10

Figure 12

CLAW

THESE SURFACES

TO BE IN LINE

46

Place a sheet of paper against pusher (#111) in its home

position (rear). Install the three paper support straps

(#127 & #83, Figure 10) 1” away from the edge of the

paper. Straps must be on top of transfer belts.
Cycle the machine by hand until the pusher has pushed

the paper to its furthest point. Install long small roller

assembly (#170, Figure 10) so that the small pulley is

top of paper.
Adjust pusher again to its home position. Place a sheet

of paper against pusher. Adjust the punch cam (#43,

Figure 8) so that when the machine is cycled by hand,

the paper is about 1” away from the front stop as it just

reaches it full up position (Figure 11). There must be an

O-ring on the paper at all times. Wheel (#167) is set on

the edges of the paper so that they turn even when the

paper is being punched.

SUPPLY STACK GUIDE

Cycle the machine by hand until the claw (#103) is in the

5 o’clock position. Position the disks as shown in

Figure 12. Disks should not be over-tightened to where

they cannot be moved by hand. Turn hand wheel to

retract the knife and load paper square to the corner

stack guide (#46).

Figure 11

167

REAR

JOGGER

SIDE

JOGGER

FRONT STOP

PULLEYS

6

Advertising