GBC Catenas User Manual

Page 31

Advertising
background image

28

I

4. Do not allow the adhesive side

of the film to contact the heat or
pull rollers. Liquefied or tacky
adhesive deposited on heat
rollers will require the rollers to
be cleaned per the section
entitled CARING FOR THE GBC
CATENA SERIES LAMINATOR.

5. Remove bottom film supply roll

from laminator then lower the
bottom film guide.

6. To load new film on film supply

shafts repeat steps 9 and 10 in
subsection Method Using Film
Threading Card.

7. Unroll enough film from the

bottom roll of film to slide under
the bottom idler bar and tack to
the existing film. Slide the bottom
idler bar back into place and
replace supply roll shaft.

8. Replace the top supply roll shaft

and unroll enough film to tack to
the existing top roll of film.

9. Install the feed table and safety

shield.

10. Set the speed for the the

slowest speed setting and
press

RUN.

11. Observe the film being pulled

through the laminator to assure
that the remaining existing film
and the new film are advancing
concurrently. Any separation
between the films will require
stopping the motor immediately
and the situation corrected.

12. Press

STOP once the newly

threaded film is completely
exiting the laminator.

4. Evitare che il lato adesivo del film

venga in contatto con i rulli di
riscaldamento o con i rulli
tenditori. I depositi di adesivo
appiccicoso o liquefatto sui rulli
di riscaldamento dovranno
essere rimossi come illustrato
nel capitolo MANUTENZIONE
DELLA PLASTIFICATRICE SERIE
CATENA.

5. Rimuovere la bobina di film

inferiore dalla plastificatrice,
abbassare la guida.

6. Per caricare nuovo film sugli

alberi del film, ripetere le
istruzioni di cui ai punti 9 e 10 del
paragrafo Utilizzo del cartoncino
di inserimento.

7. Svolgere dal rullo inferiore una

quantità di film sufficiente per
essere infilata al di sotto
dell’asta folle inferiore e
congiunta con il film
preesistente. Riposizionare
l’asta folle inferiore e rimontare
l’albero del rullo.

8. Rimontare l’albero del rullo

superiore e svolgere una
quantità di film sufficiente a
congiungerlo con il rullo di film
superiore preesistente.

9. Montare il piano di alimentazione

ed abbassare lo schermo di
protezione.

10. Impostare la velocità per la

velocità più lenta e premere il
pulsante

RUN (AVVIO).

11. Osservare il film mentre entra

nella plastificatrice per
assicurarsi che il film residuo
preesistente e il nuovo film
avanzino simultaneamente.
Qualsiasi separazione tra i film
richiede l’immediato arresto del
motore ed il ripristino della
funzione.

12. Una volta che la nuova pellicola

inserita sarà fuoriuscita
completamente dalla
plastificatrice, premere il
pulsante

STOP (ARRESTO).

Poly-out

Adhesive

surface

Polyester surface

Poly-in

Adhesive

surface

Polyester surface

POLY-IN

POLY-OUT

Rev.A 04.07.03

Advertising