GBC 150 Creasematic - Manual (Page 4)

Crease Matic 150 Operation (continued):
In ‘run’ mode the feed motor and/or crease motor may be stopped at any time by
pressing any of the four keys. To restart the feed motor, press the key.
If the feed motor is stopped and the key is pressed, the sheet counter is reset to
zero.
If the feed motor is stopped and the key is pressed, the machine will go back to
‘setup’ mode.
If the feed motor is stopped and the
key is pressed, the feed motor will run. The
machine has entered ‘edit’ mode. This is indicated by the presence of a decimal point
in the second position of the screen. This allows small changes to be made to the
existing program. Creases may not be added or deleted in this mode.
•
Feed a sheet into the creaser, it will be fed to the first crease position and then the
feed motor will stop.
•
By pressing the and keys the crease position may be adjusted. The position
of the potential crease is displayed in millimetres from the leading edge or last
crease.
•
When the crease position is reached, press the key and the crease head will
operate. The feed motor will then feed the sheet to the next crease position (if
there is one) or eject the sheet.
A slide-out, reversible creasing matrix allows card up to 350gsm to be creased.
Creasing Knife Holder
Creasing Tool
Creasing Knife
Wide tool for 200gsm
and greater
Narrow tool for
200gsm and lower