GBC 150 Creasematic - Manual (Page 6)

1. Ensure Crease Matic is in ‘setup’ mode. Decimal
point in last position of screen and LED off. Select
job number to program, then press ‘crease’. 2. Push card gently to infeed wheels. The Crease
Matic will feed the card to the creasing blade.
3. Press the ‘left’ key until distance from edge
is reached (99.00mm). Press creaser button 4. Press forward again until distance from
1st crease is reached (198.00mm).
Press creaser button
5. Press forward again until sheet is out onto the
collection tray, the next sheet will now go in and the
same creases will be repeated, 6. Press forward again until sheet is out onto
the collection tray, the next sheet will now go in and the
same creases will be repeated,
New Job Setup: