GBC BM 200 Bookmaker - Manual (Page 18)

1
18
Docking the Booklet Maker to a Collator, custom paper sizes
By loosening the knob (4), the docking assembly can
be individually positioned for custom paper sizes.
Loosen the knob (4).
Position the Booklet Maker so that the sets (5) fed
from the collator (6) enters the Booklet Maker infeed
assembly centered (7).
Note
The knob (4) which prevents the infeed assembly
from moving, can not be thightened when the colla-
tor is docked to the Booklet Maker. If you want to be
sure not to loose positioning, carefully undock the
Collator from the Booklet Maker and thighten the
knob.
4
Push the docking assembly to the rear until it
locks.
Separate the Collator from the Booklet Maker.
Adjusting docking assembly to factory settings
To adjust the docking assembly back to factory
setting:
Loosen the knob.
Slide the docking assembly so that it covers half
the hole (6) in the infeed assembly.
Tighten the knob.
6
Undocking the Booklet Maker from a Collator
Basics
7
5
6