GBC BM 200 Bookmaker - Manual (Page 20)

1
20
Basics
Look inside stapler head for jammed staples in the area
of the staple actuator. Remove staples if any.
Position the stapler head on the edge of a firm surface
(for example the top of a table).
While securely holding the head, actuate the Stapler
up and down through full travel. Perform this operation
without staple cartridge
Renewing or reinstalling the staple cartridge, pull 25
mm (1 inch) of staples out of the cartridge and tear the
staples downward starting at one side pulling away
from you. The staple tear line is indicated by an arrow
on the side of the cartridge.
Insert the cartridge into the stapler head with the end
of the staples facing toward the head of the stapler
mechanism. Push it firmly ahead.
Hold the staple cartridge firmly in place and push down
the cartridge locking lever.
Note
Keep holding (pushing) the staple cartridge into place while
pushing down the cartridge locking lever.
While securely holding the head, actuate the Stapler up
and down through full travel. Perform this operation with
staple cartridge. Repeat this a few times to ensure that
the staples are ejected at each down movement.
Reinstall the stapler head by inserting the pin at the top of
the stapler head into the stapler retraction swing arm (D).
While rotating the stapler head, insert the pin located
at the rear end of the stapler head into the slots in the
frame of the stapler head assembly. Press down the
rear end of the stapler head until the release lever snaps
into place, locking the stapler head in position.
Press down the front end of the stapler head until it
snaps in position under the frame assembly.
Reconnect the staple indication lead (A), see previous
page.
Close the top cover and press the [Esc] button. The
booklet maker will automatically go to Ready mode. If
not and/or error message persists, hand feed a four
sheet set of paper. The booklet maker will automatically
cycle and advance staples until both stapler heads are
driving staples. The booklet maker will automatically go
to Ready mode.
Installing stapler head, staple cartridge / clearing staple jam
D