GBC 620OS - Manual (Page 12)

GBC 620os Operation Manual
© 2007 General Binding Corporation Page 12
FEATURES/ACCESORIES GUIDE
Figure 12
Figure 13
Figure 14
PULL ROLLERS
(Fig. 12– Item F1)
The Pull Rollers are silicone driven rollers that pull the
film and media through the machine and into the Bursting
Rollers.
SKEW WHEEL
(Fig. 12– Item G1)
For proper “snapping” of images, the out put must have a
“skew” in the paper or a raised “tent” on one side of the
output. By adjusting the Skew Wheel, you can adjust the
amount of “Skew” or “Tent” needed for proper “snapping”.
SKEW WHEEL PRESSURE ADJUSTMENT
(Fig. 12– Item G2)
The Skew Wheel Pressure Adjustment can be made by
turning the screw down for more pressure and up for less.
SKEW WHEEL LOCK DOWNS
(Fig. 12– Item G3)
The Skew Wheel Lock Downs secure the Skew Wheel to
the shaft. These are used to relocate the Skew Wheel as
needed.
IN LINE PERFORATOR WHEEL
(Fig. 12– Item H1)
The In Line Perforator Wheel “perfs” the edge of the film
allowing the images to be “snapped” or “separated”.
PERFORATOR WHEEL TENSION ADJUSTMENT
(Fig. 12– Item H2)
The Perforator Wheel Tension Adjustment can be made
by turning the screw.
PERFORATOR WHEEL LOCK DOWN
(Fig. 12– Item H3)
The Perforator Wheel Lock Down secures the Perforator
Wheel to the shaft. This is used to relocate the Perforator
Wheel as needed.
OUTPUT FEED BELTS
(Fig. 12– Item I1)
The Output Feed Belts assist the finished images into the
Burst Rollers.
PAPER GUIDES
(Fig. 13– Item J1)
The Paper Guides catch and orientate the finished images.
REAR SAFETY LATCHES
(Fig. 13– Item K1)
The Rear Safety Latches lock the Rear Safety Shield into
place.
REAR SAFETY SHIELD
(Fig. 13– Item L1)
The Rear Safety Shield protects the operator from harm.
REAR TABLE
(Fig. 13– Item M1)
The Rear Table catches the finished product.