GBC 620OS - Manual (Page 9)

GBC 620os Operation Manual
© 2007 General Binding Corporation Page 9
FEATURES/ACCESORIES GUIDE
Refer to the following pages for detailed Features. information on the
Figure 1
Fig ure 2
Fig e 3 ur
Figure 4
ement. To disengage, turn the EMERGENCY
atches ensures that
serted properly and if not
perate.
afety Shield prevents entanglement,
inadvertent contact with the Heat Roller.
is used to take up any film that is being slit
Slitters.
he Nip. It
cording to the paper size selected on the
an even and accurate overlap.
images into the Feed Gate and
mG)
ccurate
and film being used, the
to assist in the
mount
ator. The Decurling Bar is
lls and the Pull Rolls.
te when the next sheet
eed Table. Sheets should not be
inated.
The Feed Gate Stops can be adjusted up, down, and left to
right to accommodate various media paper thicknesses.
EMERGENCY STOP BUTTONS
(Fig. 1– Item A)
There are two EMERGENCY STOPS on the laminator.
One is located at the rear of the machine and the other is
located on the front.
To engage, press any EMERGENCY STOP to stop the
roller mov
STOP clockwise after the emergency condition has been
resolved.
FRONT SAFETY SHIELD INTERLOCK LATCHES
(Fig.1-Item B)
The Front Safety Shield Interlock L
the Front Safety Shield is in
achine will not o engaged, the m
FRONT SAFETY SHIELD
Fig.2-ItemC) (
The Front S
entrapment, and
REWINDER
Fig.2-ItemD) (
The Rewinder
In-Line via the
FEED GATE
(Fig.2-ItemE)
he Feed Gate controls the images entering t T
will activate ac
e display, and giv
FEED BELTS
Fig.2-ItemF) (
The Feed Belts move the
t
ip. hen into the n
TABLE SIDE GUIDES
(Fig.2-Ite
The Table Side Guides are adjustable to ensure a
feeding.
BURST ROLLER GAP ADJUSTMENT KNOB
(Fig.3-ItemH)
The Burst Roller Gap Knob raises and lowers the Burst
oller. Depending on the media R
operator can raise or lower the Burst Roller
ing of the images. Burst or Snapp
DECURLING ADJUSTMENT KNOB
(Fig.3-ItemI)
The Decurling Adjustment Knob is used in conjunction
with the film shaft brake to increase or decrease the a
of curl desired by the oper
n the Main Ro located betwee
FEED INDICATOR LED
(Fig.4-ItemJ)
The Feed Indicator LED will indica
can be placed on the F
LED is illum placed until the
FEED GATE STOPS
(Fig.4-ItemK)