GBC 620OS - Manual (Page 6)

GBC 620os Operation Manual
© 2007 General Binding Corporation Page 6
RE-INSTALLATION
P
Before a 620os Laminator can be installed, ensure the
llowing requirements are met:
the
site?
provides space for efficient
d vapor
ed air.
e rollers and result in
poor output quality.
nt protection and safety lockouts
available?
ase.
ct a licensed
achine is supplied with a Nema 6-15 male
Plug.
STALLATION
fo
1. Are doorways and hallways wide enough for
laminator to be moved to the installation
2. Is there ample room for the laminator?
• A work area must be established that allows
for operation in both the front and rear of the
laminator and
material flow.
3. Is the environment appropriate for the laminator?
• The laminator requires a clean, dust an
free environment to operate properly.
• Avoid locating the laminator near sources of
heat or cold. Avoid locating the laminator in
the direct path of forced, heated or cool
CAUTION: Air flow can cause uneven
heating / cooling of th
4. Have you contacted a certified electrician to wire
the receptacle and ensure that adequate power is
being supplied, having the appropriate capacity,
over curre
GBC 620os Requires:
• 220V at 60Hz with 20 Amps single ph
• Nema 6-15 P 15 A 250 V Receptacle
• A Buck Booster may be needed if voltage is
not correct. Please conta
electrician to install if needed.
This M
IN
1. Shipping damage should be brought to the immediate attention of the delivering carrier.
inator as it exits the equipment may cause the film to wrap around the pull rollers,
minator near sources of heat or cold. Avoid locating the laminator in the direct path of forced,
lock the castors in place. Locking the castors prevent the machine
u which the laminator is connected, as this may result in nuisance tripping of
circuit breakers or blowing fuses.
Note:
ll on right and left side of the
roll. Finally, check by placing the level diagonally across lower main to lower pull rolls.
2. With assistance, carefully roll the laminator into position over flat and even surfaces.
3. The laminator should be positioned to allow exiting film to flow freely to the floor or a work table. Accumulation of
laminate immediately behind the lam
resulting in a “jammed” condition.
4. Avoid locating the la
heated or cooled air.
5. Once the laminator has been properly positioned,
from rolling during set up, operation or servicing.
6. Connect the attachment plug provided with the laminator to a suitably grounded outlet. Avoid connecting other
equipment to the same branch circ it to
Machine must be leveled to ensure best performance. Level the machine by lowering both the main and pull rollers.
Lay a
level on top of the main and pull rolls. Then, check level from main roll to pull ro