GBC 44DT - Manual (Page 19)

Page 6-3
Operating Instructions
44DT
IMPORTANT: The top and bottom rolls of laminating
film must be the same width.
Always change the top and bottom supply rolls at
the same time. Near the end of each roll of most
laminating film is a label stating,
Warning – End
of Roll. The appearance of this label on either the
top or bottom roll requires that new rolls of film
be installed as soon as the item presently being
laminated completely exits the rear of the laminator.
Do not introduce any additional items into the
laminator when the warning label is visible.
Adhesive will deposit on the rollers if:
One or both rolls of film are allowed to run
completely off its core.
Only one roll is used.
Different widths of rolls are loaded together.
Either roll is loaded with the adhesive side
against a roller.
There are two methods of loading film.
Using a threading card.
Tacking new film to existing film.
Prior to loading film, the safety shield and feed table
need to be removed.
•
•
•
•
•
•
R
EMOVING AND
I
NSTALLING THE
S
AFETY
S
HIELD
The safety shield should not be removed except to
install films and when cleaning the rollers. When the
shield is off, the laminator runs at a fixed speed of 3
fpm (0.9 m).
WARNING: Keep fingers and hands away from
the rollers when the machine is running. They could
be burned and trapped and crushed in the rollers.
Clothing, jewelry, and long hair could be caught in
the rollers and pull you into them.
To remove the shield:
Tilt the bottom of the shield out.
Lift shield up and out.
To install the shield:
Align the pins at the back of the shield with the
slots on the machine.
Lower the shield so that it engages the safety
switch.
1.
2.
1.
2.