GBC 44DT - Manual (Page 20)

Operating Instructions
Page 6-4
44DT
R
EMOVING AND
I
NSTALLING THE
F
EED
T
ABLE
The feed table should not be removed except to
install films. When the table is off, the laminator runs
at a fixed speed of 3 fpm (0.9 m).
To remove the feed table:
Slide the feed table latch to the right.
Lift the table upwards and away from the
laminator.
To install the feed table:
Place the table on the machine.
Slide the feed table latch to the left.
1.
2.
1.
2.
L
OADING
F
ILM
O
NTO THE
S
UPPLY
S
HAFTS
If you are replacing existing films, perform the
following set of instructions,
To remove existing films.
If you are loading film for the first time, skip these
instructions and start with the next instructions,
To
load films.
To remove existing films:
Put the roller pressure handle to Release.
Fig. 6-5. Roller Pressure Handle.
Cut the remaining top and bottom films just
ahead of the heat pressure rollers.
Do not allow the remaining film to pass through
the laminator if there is any exposed adhesive.
Liquefied or tacky adhesive will deposit on the
rollers if the following step is not followed.
Pull the remaining film out the back of the
machine with a quick motion.
CAUTION: Be careful to not cut the heat pressure
rollers. Failure to observe this notice can damage the
rollers.
1.
2.
3.