GBC 500 electric - Manual (Page 44)


G
General safeguards
• Use the unit for its intended purpose only.
• Place the unit on a secure, stable work area to prevent the
unit from falling and possibly causing personal injury and
damage to the unit.
• Follow all warnings and instructions marked on the unit.
• Test the punching system with a scrap piece of paper first.
• Take care that there are no staples or such like in the
document prior to punching.
• Do not place anything in the punching entry other than paper
up to 26 sheets (80gsm) or one PVC plastic binding cover up
to 0.18mm Empty both the clippings tray and the waste pin
tray regularly.
• Wipe exterior only with a damp cloth. Do not use
detergents or solvents.
• Do NOT use aerosol dusters or cleaners.
• Do NOT spray anything into the machine.
• Foreign substances can be explosive.
m
Cleaning
Guarantee
Operation of this product is guaranteed for 2 years, from date
of purchase, subject to normal use. Within the guarantee
period, ACCO Brands Europe will at its own discretion repair
or replace the defective machine free of charge. Defects due
to misuse or use for inappropriate purposes are not covered
under the guarantee. Proof of date of purchase will be required.
Repairs or alterations made by persons not authorised by
ACCO Brands Europe will invalidate the guarantee. It is our
aim to ensure that our products perform to the specifications
stated. This guarantee does not affect the legal rights which
consumers have under applicable national legislation governing
the sale of goods.
Register this product online at www.accoeurope.com
Setting up
1 Retain the packaging in case you need to return the
machine for repair. Place on a secure, stable surface.
2 The machine is divided into two parts, one for punching
and one for binding. This means that one person can be
punching while another person is binding.
3 The punching mechanism is coated with a protective film,
which will mark your paper. So, prior to punching your first
document, clear this film by punching some scrap sheets of
paper until the paper comes out clean.
Punching the document
1 Adjust the punch edge guide to the correct paper size.
Remember to tighten the screw of the guide. (see fig 1-1a)
2 Place the paper fully into the punching entry and slide the
paper to the left against the punch edge guide (see fig 2).
3 Press the two punching panels downward until your
document is punched (max 26 sheets) (see fig 3a).
Alternatively you can punch one section with one panel and
then repeat using the second panel (see fig 3b).
4 Remove the punched paper from the punching entry.
5 Repeat this operation until all your sheets of paper have
been punched.
Important: If punching PVC covers, insert no more than
one cover at a time as this material, in large quantities,
could cause jams or excessive wear. It is recommended to
punch a PVC cover at the same time as 1 sheet of normal
paper. This will give better quality punching results.
Waste trays
• Remove the covers and empty the contents of the waste
trays on a regular basis, to prevent clogging and possible
damage (figs 4).
Specifications
GBCSureBind500
26 sheets (80gsm) 30 sheets (70gsm)
1 sheet PVC Plastic Cover (0.18mm)
1 sheet PP Cover (max 700 gsm)
1 sheet cardboard Cover (max 450 gsm)
DIN A4, A3, A2
A4 10 pin, A3 14 pin
500 sheets
2 inch
7.3kg
500x400x145mm
MaxPunchCapacity
MaxPunchCapacity

DocumentSize
PunchingPattern
MaxBindCapacity
MaxStripSize
NetWeight
MachineDimensions