Installing the speedvault – GunVault SVB 500 User Manual

Page 4

Advertising
background image

- 3 -

Z

Step 1. Select a location to mount the unit.




Step 2.

Secure the “Mounting Bracket” to the desired location
using the

“Wall Mounting Holes” and the wood screws.






Step 3. Keeping the unit closed, remove thumb screws at the

bottom of the unit (use of pliers is recommended). After
removing thumbscrews, remove the bracket.

Step 4. Place the SpeedVault

®

on a flat surface and use the key

to unlock the unit; Pull the drawer off separating it
completely from the unit.

Step 5. The battery tray is on the inside roof of the unit. Open the

battery tray door and insert new 9v Alkaline battery,
following the Positive (+) and Negative (-) guides on the
holder. Close the battery tray door when finished.

Step 6.

Align the shell of the unit to the “Mounting Bracket” using
the “Hook Mounting Holes” as a guide. Secure using the 3
thumb screws turning them clockwise until tight.

Step 7. Reinstall the drawer by replacing the bracket and two

“Thumbscrews”.

Step 8. The SpeedVault

®

is now ready for use.





Mounting screws provided are for solid wood surface only. If mounting to
another surface type (drywall, cement, etc.) the appropriate hardware can be
purchased through a local hardware store.

Unit is sold at factory default and pressing the start button will open the unit.
To change this, see Programing SpeedVault

®

.

The SpeedVault

®

uses gravity to drop the drawer open and will need enough

space in front of unit to fully open.

INSTALLING THE SPEEDVAULT

®

Advertising