GunVault SVB 500 - Manual (Page 6)

- 5 -
Step 1. After enrolling the first two administrator fingerprints, open the
unit using key or biometric scanner and press the Learn/Mute
Button. You will hear one beep and the LED will turn green
indicating the enrollment procedure has started.
Step 2. Swipe the administrator fingerprint from Position 1 to Position
2 and you will hear two beeps indicating the additional
fingerprint is ready for enrollment.
Step 3. Place the finger you want to enroll over the scanner with the tip
of your finger at the top of the finger guide.
Step 4. Make sure you have good, flat contact with the scanner. Begin
to swipe your finger from Position 1 to Position 2, taking 1 to 2
seconds to complete the swipe. A single beep will indicate a
successful swipe and red flash indicates an unsuccessful
swipe.
Step 5. Once the swipe is completed you will hear a beep. Repeat Step
3-4 until you hear a double beep this indicates a successful
enrollment.
Fingerprint Access
Step 1. Press the Start button; unit will flash green twice and beep
once.
Step 2. Place a programed finger on the scanner with the tip of your
finger at the top of the finger guide.
Step 3. Make sure you have good, flat contact with the scanner. Begin
to swipe your finger from Position 1 to Position 2, it will take 1 to
2 seconds to complete the swipe. Try to get your entire
fingerprint to cross the scanner.
Step 4. If the unit detects a match, the LED will flash green two times
and you will hear two beeps, then the unit is open.
Step 5.
If the unit doesn’t detect a match, the LED will flash green and
red, you will be denied access. If an enrolled user is denied
access, please try again.
GunVault ® Tip: You go to the range and practice with your gun; practice accessing your
gun with your GunVault as well. Practice will assure you have proper training to access your
safe.
ENROLLING ADDITIONAL USERS
ACCESSING THE UNIT