HCO SG565FV - Manual (Page 13)

Scouting Camera SG565FV
4 Advanced Operations
Page 11
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Capture Number or Photo Burst.
c) Press RIGHT to select 3 Photos.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
Note: When use flash light, the photo burst function will be forbidden .
4.1.8 Set Video Length
This parameter is effective and can be adjusted only when the device in the video
mode for the ON mode. Its value extends from 1 to 60 seconds with a step of one
second. Press RIGHT to decreases or increases the value by 1 second.
The following shows how to set video length to 5 Seconds provided that the
previous value is 1 Seconds:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Video Length.
c) Press RIGHT to increase to 5 Seconds.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and exit.
Note : If there is not sufficient daylight , the Video mode will be forbidden in
TEST mode and it will turn to camera mode automatically in ON mode.
4.1.9 Set Triggering Interval Time
This parameter means that how long the PIR (Passive Infrared motion sensor)
will be disabled after each triggering in ON mode. During this time the PIR of the
device will not react to the motion of humen(or animals). The minimum interval is 1
second. The maximum interval is 1 hour. The default value is 1 minute.
Press RIGHT to decreases or increases the value by 1 second or 1 minute.
The following shows how to set triggering interval time to 5 Minutes provided
that the previous value is 1 Minute.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Interval.
c) Press RIGHT to decrease or increase to 5 Minutes.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.10 Set PIR Sensitivity
This parameter defines the sensitivity of the PIR. There are three parameters:
High, Normal, and Low. The default value is “Normal”. The higher degree indicates
that the
Camera is more easily to be triggered by motion, taking more pictures or
recording more videos. It is recommended to use high sensitivity degree in room or
environment with little interference, and to use lower sensitivity for outdoor or
environment with lots of interference like hot wind, smoke, near window etc.
Furthermore, the sensitivity of the PIR is strongly related to the temperature. Higher
temperature leads to lower sensitivity. Therefore it is suggested to set a higher
sensitivity for high temperature environment.