HCO SG565FV - Manual (Page 7)

Scouting Camera SG565FV
3 Quick Introductions
Page 5
3 Easy Operations
3.1 Power Supply
To supply power for the camera, four AA size batteries are needed.
Open the bottom cover. Confirm that the power switch is at the OFF position.
Install the fully charged batteries into the depot according the polarities sign shown
below. The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries (Recommended)
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are two battery slots.
When in low-battery state, camera will be automatically shut down after two
indication sounds. Please change the batteries in time.
3.2 Insert the SD-card
Open the bottom cover. Insert SD-card into the card slot with unmarked side
upwards. Please note that the SD-card can only be plugged in one direction. Make
sure that the write-protect switch of the SD-card is on the “write” position otherwise
the camera cannot be switch on.
3.3 Power on and Entering into the ON Mode
The Camera has three basic operation modes:
1. OFF mode: to turn off the camera.
2. TEST mode: to set operational parameters, or to playback the photos or video
clips via display screen or via TV.
3. ON mode: to work at surveillance state.
Before switching on, please pay attention to the follows:
1. Avoid temperature and motion disturbances in front of the camera such as big
leaf, curtain, air-conditioner, air outlet of the chimney and other heat sources