Human Touch HT-5005 Massage Chair - Manual (Page 4)

humantouch.com
6
ENGLISH
Unpack the box
1. Unfold the chair
Remove all packaging materials from the
chair. Pull up on the backrest to unfold the
chair to an upright position. The backrest
locks into place automatically.
2. Attach the backrest pad
Open both backrest pad zippers completely.
Slip the pad over the backrest and pull down firmly.
get ready
Your Human Touch massage chair requires some simple
assembly (no tools required). Just install the backrest
pad and the seat pad, and you’re done!
3. Close the backrest pad zippers
a. Close the zipper on each side of the backrest pad.
b. Smooth the front of the backrest pad from the top
toward the bottom of the backrest.
c. Ensure that the flap on the bottom front of the
backrest pad is resting flat on top of the seat canvas.
d. Locate the cables at the rear lower left-hand corner
of the backrest. Pass the cable window flap under
the cables, then smooth the flap flat to complete the
cable window. For best appearance, center the cable
window over the power panel.
4. Attach the seat pad
Place the seat pad into position with the seat pad flap facing forward
and the front edge of the pad aligned with the front edge of the chair
arms. The seat pad automatically attaches to the chair using the
hook and loop fasteners.
5. Tuck in the seat pad flap
Tuck the flap on the front of the seat pad between the chair frame
and the foot and calf massager, then press upward on the flap to
secure it to the bottom of the chair.
7
Seat Pad Backrest Pad Chair
Flap rests on top of
the seat canvas
Bottom back of
the backrest pad
Cable window flap