Kenco Engineering 9958 - Bar Magnet - Manual

Installation Instructions for MLG Level Gauges with Float Containing a Bar Magnet
Switch should be mounted adjacent to or 180
° from MLG flag assembly if gauge is equipped with a float containing a bar
magnet. If gauge is equipped with a float containing a 360 ° magnetic flux field, switch should be mounted as illustrated on
opposite side of page. See illustrations above for proper location of ½” FNPT conduit connection relative to switch
support clamp when gauge is equipped with a float containing a bar magnet.
Switches can be located as close as 3-1/4” from each other if mounted end to end. Closer switch trip point distances can
be obtained by staggering switch body locations as required.
Switch Specifications:
-----See Installation Instructions for MLG Level Gauges with Float containing a 360º Magnetic Flux Field-----
KENCO ENGINEERING COMPANY • P.O. BOX 470426 • TULSA, OK 74147
PHONE: (918) 663-4406 • TELEFAX: (918) 663-4480