Change remote access security pin code, Switch answering machine on, Check for messages – BT STUDIO 4500 User Manual
Page 38
38
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or email [email protected]
Change remote access security PIN code
1
. Press the
button, the display shows
anS
Machine
, press .
2
. Press
or
until
anS
SeTTingS
is displayed and press
to select.
3
. Press
or
to display
change
Pin
and press .
4
.
OlD
Pin?
is displayed, enter the current PIN and press .
5
.
neW
Pin?
is displayed, enter your new PIN and press .
Re-enter the new PIN when the display shows
cOnFirM?
and press .
6
. Press and hold to return to standby.
Switch answering machine on
If you forget to switch on your answering machine before leaving
home, you can do it from another phone.
1
. Dial your phone number and after 20 rings your BT Studio
4500 will answer. When the message starts press
*
and
you will hear, “Please enter your security code”. Enter your
4-digit code.
2
. Press
7
to switch the answer machine on.
Check for messages
1
. Dial your phone number. When you hear your outgoing
message, press
*
. You will hear, “Please enter your
security code”.
2
. Enter your 4-digit code and your machine announces
“To hear main menu, press 1. Press 1 to listen to menu options
or press 2 to play all messages”. The new messages are then
automatically played back to you.
If you enter the incorrect PIN code,
you will hear “Incorrect security
code”. You have two chances to enter
the correct remote access security
code before your BT Studio 4500
hangs up.
Time saver
If you have set the answer delay to
Time Saver, your answering machine
will answer after 2 rings if you have
new messages. If you do not have new
messages it will answer after 6 rings.
This enables you to hang up if you
hear more than 2 rings before you are
connected, saving you the cost of a
call. See Answer delay, page 37.
If you do not press any button for
4 seconds during Remote access,
your BT Studio 4500 will hang up.
Keep a note of your remote access
security PIN code by writing it in
the space provided on page 48.
The default PIN setting is 0000.