Inserting lamps applying gel to gel frame – Kino Flo BarFly 100/200/400 User Manual
Page 6
Advertising
6
Inserting Lamps
Applying Gel to Gel Frame
Insert lamps at a 45° angle and align pins
with lamp holder.
Gently lay lamp down into fixture.
If you feel resistance, the lamp is not
properly aligned. Start again.
Apply adhesive transfer tape to the
gel frame.
Press lamp securely into lamp clip.
Lay the adhesive side on the gel and trim
off excess gel with a matte knife.
Advertising
See also other documents in the category Kino Flo Lighting:
- 4Bank (BAL-427) (16 pages)
- 4Bank DMX (BAL-457) (16 pages)
- BarFly 200D (12 pages)
- BarFly 450 DMX (16 pages)
- BR1 Ballast Boards (4 pages)
- Celeb 200 DMX LED (20 pages)
- Celeb 400 DMX LED (20 pages)
- Celeb 400Q DMX LED (16 pages)
- Desk-Lite (8 pages)
- DG4 Ballast Board (3 pages)
- DS1 Ballast Board (2 pages)
- Dim 5 Remote Dimmer (4 pages)
- Diva-Lite 401/201 & 400U (16 pages)
- Flathead 80 DMX (427, 457) (16 pages)
- Image 87/47 DMX Series (20 pages)
- Imara S10/S6 DMX (20 pages)
- Lamp Tester (4 pages)
- Mega 4Bank DMX (BAL-455M) (16 pages)
- Mega Double (16 pages)
- MG4R Ballast Board (4 pages)
- Mini Flo 139X (8 pages)
- ParaBeam 410/210 DMX (20 pages)
- ParaZip 400/200 DMX (16 pages)
- Tegra 4Bank DMX (TEG-450) (16 pages)
- TG1 Ballast Board (4 pages)
- True Match 26W CFL (4 pages)
- VG4R Ballast Board (4 pages)
- VG5R Ballast Board (4 pages)
- VistaBeam 610/310 DMX (20 pages)
- Vista Single (16 pages)
- 12V Single Kit (9 pages)
- BarFly 400D (12 pages)
- Blanket Light 6X6 (14 pages)
- Blanket Light 6X6 DMX (19 pages)
- Foto-Flo 400 (14 pages)
- Celeb 200 LED (12 pages)
- Foto-Flo 44 (9 pages)
- Flathead 80 (BAL-410) (12 pages)
- Flathead 80 DMX (415, 455) (16 pages)
- Image 80, 40 & 20 DMX (16 pages)
- Image 82, 42 & 22 (11 pages)
- Image 85/45 DMX Series (20 pages)
- Kamio Kit Kam 6 (12 pages)
- Kamio Kit Kam 6E (12 pages)