Kino Flo Trans-Flo - Manual (Page 2)

The TRANS-FLO SYSTEM is a standard-output ballast that can
be dimmed on most common theatrical SCR dimming systems.
The modular design of the TRANS-FLO SYSTEM streamlines
set lighting installations, and its smooth dimming capability
ensures controlled lighting effects.
The TRANS-FLO Ballast can operate 15-inch, 2ft, 3ft and 4ft
lamps in pairs; two different sized lamps can be powered from
the same ballast. (Two lamps must be connected for the ballast
to operate.)
The POWER/DIM Cable provides primary voltage and dimming
control to the first TRANS-FLO Ballast. The Single Locking
Lamp Harnesses attach directly to each ballast, or they attach to
a ballast via a Head Extension ( up to 25ft long ).
Jumper Cables link TRANS-FLO Ballasts together ( up to 10 in
a series ).
The TRANS-FLO SYSTEM operates in three modes:
1. INDIVIDUAL BALLAST DIMMING MODE ( two
lamps )
2. SERIES BALLAST DIMMING MODE (up to 10
ballasts per series )
3. NON-DIM MODE
To operate, the TRANS-FLO SYSTEM in the Individual Ballast Dimming Mode
you need a minimum of:
2
TRANS-FLO Power & Dim
Cable, 6ft.
Primary power feed line and
dimming line ( both with
Edison connectors). One
cable per ballast is needed
for individual dimming
control. TRANS FLO Two-Lamp
Ballast, 120 VAC
A standard-output, flicker-
free electronic dimming
ballast. Operates two 15-
inch, 2ft, 3ft or 4ft lamps. Lamp w/ Harness ( need
two per Ballast )
15-inch Med Bipin
2ft Med Bipin
3ft Med Bipin
4ft Med Bipin