Krell Phantom Manual - Manual (Page 21)

21
Remote Control Description
See Figure 2 on the previous page
The Phantom remote provides the same power, preamplifier, level control, and
navigate/customize functions as the preamplifier’s front panel. In addition, the
remote has CD and DVD functions, and menu configuration functions.
Keys Labled 1 to 14
These remote keys have the same function (and callout number) as the
corresponding front panel controls described in the preceding pages.
Keys Labled A to J
These remote keys have functions that are unique to the remote control,
and are described below.
Battery Installation and Removal
The remote control uses 2 AAA-size 1.5 Volt batteries. Batteries are included
with the shipment. To install the batteries:
1. Remove the remote control backplate, using the supplied T-10 Torx
wrench.
2. Install the batteries, following the battery position diagram on the plastic
battery receptacle.
3. Replace and secure the backplate.
Notes
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long period of time. Battery
leakage can damage the remote control.
Amplifier Functions
A Amp Pwr Key
Use this key to activate Krell amplifiers connected to your system.
B Sel (Meter Select) Key
Use this key to select the meter range of the power meter scale on the
front of a Krell Evolution One power amplifier. Please refer to the Evolution
One Owner’s Reference, for more information.
(SECTION FOUR: Anatomy of an Phantom continued)