Usa & c, Rear view all cooktops – La Cornue Château Series - Gas & Electrical Requirements User Manual

Page 3

Advertising
background image

Page

30

LA CORNUE

Installation Guide Centenaire

08NOTINSTAL100/USA-2

USA & C

AN

AD

A

Electrical connection

I

NSTALLATION

The appliance must be electrically installed and grounded in accordance with local
codes or in the absence of such codes with the latest edition of the "National Electrical
Code", ANSI/NFPA 70 in the USA, and CSA C22.2 "Canadian Electrical Code” - in
Canada.

Disconnect all the power supply circuits before accessing the junction boxes.

This appliance must be supplied with 240 Volt and 60 Hz frequency, and
connected to an individual, properly grounded branch circuit, protected by
a circuit breaker or time-delay fuse, as noted on the rating plate.

Use only a 3-wire or a 4-wire UL-listed power-supply cord rated 120/240
Volts with a straight terminals.
Only a 4 wire cord is to be used when the appliance is installed where
grounding through the neutral conductor is prohibited, such as:
- new branch-circuit installations (1996 NEC),
- mobile homes,
- recreational vehicles or
- in an area where local codes prohibit grounding through the neutral.

The power of the electric elements for each appliance see page 11 and pages 12 - 22.

Wiring must conform to National Electric Codes.
If the electric service provided does not meet the above specifications, have a licensed electrician
install an approved outlet.

Because range terminals are not accessible after range is in position, flexible service conduit or cord
must be used. The range can then be easily disconnected for servicing etc.

The "La Cornue" appliance is supplied with a connection terminal block accessible by unscrewing
the stainless steel protection plate on the backside.

1. Remove the screws and the protection plate on the backside of the ranges.
For the cooktops remove the cover of the main terminal box.

1. E

LECTRICAL CONNECTION

G-Ground N-Neutral
Ph-Phase

Electrical
connection
Terminal
Block

Gas Inlet Male
1/2 NPT connection

1 1/2“ (40 mm)

7 5/8“

(195 mm)

Rear view All Cooktops

Ranges

Cooktops

Advertising