Reloop TERMINAL MIX 2 - Instruction Manual - Manual (Page 22)

ENGLISH
22
3.2.2 Serato DJ Intro Installation / mac OSx
On the included installation CD you can find the directory “Serato DJ Intro”. Open it and select the setup file that corresponds to your system.
Now start the installation with a double click.
1. Please carefully read the license agreement and accept it by clicking “I agree”.
2. Now drag and drop the file “Serato DJ Intro” in your “Programs” folder.
3. You can now start Serato DJ Intro via your “Programs” folder.
3.3 Traktor Support
Reloop provides Traktor mappings (4-deck, 2-deck, 2 sample decks) which you can download from our forum. An instruction how to embed the
mappings can also be found in our forum. http://www.reloopdj.com/forum
4. OpEraTIOn
4.1 Software function Chart
After the Reloop Terminal Mix 2 has been properly connected and correctly configured in the DJ software it can now be used.
SURFACe
NO deSIGNATION SHIFT deSIGNATION
T1 Pitch Fader
Adjusts the current deck's pitch (see -T23-).
T2 Offset LED
If you switch the deck (see -T23-) and move the pitch fader the value will be
stored. The LED shows whether the pitch fader is at its initial value when
setting back.
T3 Range
You can select between the following pitch fader ranges:
8%, 16%, 50%
T4 Keylock
(De-)activates keylock.
T5 Effect Parameter
Changes the selected effect's effect parameters in the respective slot.
T6 FX On Button
Activates the selected effect in the respective slot. Effect Switch Button
By pressing this button the effect in the respecti-
ve slot can be changed.
T7 FX Tempo
Changes effect tempo of all effects.
T8 Tap Button
Determines the effect section's tempo.
T9 Loop Length
By turning the encoder the set loop's length will be varied. By pushing the
encoder an automatic loop will be set with the selected loop length; it is not
necessary to set the loop ending point.
T10 Adjust beginning of loop
Sets a loop-in point. If a loop is set, the loop-in point can be adjusted via the
jog wheel when pressed again.
T11 Adjust loop ending point Sets a loop-out point. When pressed again the loop-
out point can be adjusted via the jog wheel.
T12 Moving a loop
Moves the loop in a bar.
T13 Hot Cue Buttons
Herewith the 4 hot cues of a track can be accessed. If a hot cue is unassi-
gned (no LED feedback) the hot cue will be assigned to the current track
position by pressing the button -T23-. Delete Hot Cue
If you press a hot cue in shift mode, it will be
deleted.
T14 Slice Button
Reserved for future software updates.