Clarion MAX973HD - Manual (Page 175)

79
MAX973HD
English
IN
ST
AL
LAT
ION
AND
WIR
E
CONNE
CT
ION MA
NUAL
INSTALLATION AND WIRE
CONNECTION MANUAL
Safety Precautions
Before use
Notes on the place to install to
CAUTION
• Do not install the system in the locations
described below. This may cause a fire,
accident or electrical shock:
• A location exposed to rain or dust.
• A location interfering with the driver's visual
range or operation of the vehicle.
• An unstable location, or where the system
may fall.
• Do not install this unit in a place exposed to
direct sunlight or heat, or a place where the
vent holes or heat radiation holes are
covered.
• When you install the antenna, mount it in a
place where the elements of the antenna do
not protrude beyond the edge of the front,
back, left and right of the vehicle. If it comes
in contact with pedestrians, it may cause an
accident.
Installation notes
CAUTION
• Use only the supplied parts. If unspecified
parts are used, they may cause damage.
• Any holes made in the body of the vehicle
should be sealed with a silicon adhesive. If
exhaust fumes or water penetrates into the
vehicle, this may cause an accident.
• Fasten the bolts securely when installing
the unit. If the bolts are loose, an accident
or malfunction may occur.
WARNING
• Confirm the battery voltage of the vehicle
to be installed. This unit is designed only
for vehicles with DC 12V power supply.
• Disconnect the negative terminal of the
battery before connecting wires,
otherwise an electric shock, injury by
short circuit may occur.
WARNING
• When installing the unit to a vehicle with
an airbag system, never install it in a
place where it may interfere with the
operation of the airbag.
• Do not install this unit in the following
locations:
• A location interfering with the driver's
visual range or operation.
• A location where the gear lever or brake
pedal operation is hindered.
• A location where passengers are at risk.
• An unstable location, or where the
system may fall.
Car battery
WARNING
• Please note the position of pipes, tanks
and electrical wirings before installing
the unit into the vehicle. Failure in
avoiding these may cause a fire or
malfunction.