Clarion MAX973HD - Manual (Page 185)

Wire Connection
89
MAX973HD
English
IN
ST
AL
LAT
ION
AND
WIR
E
CONNE
CT
ION MA
NUAL
Connecting to the CCD camera for vehicle
Connect the CCD camera for vehicle to the CCD camera terminal on the main unit. For detailed
information, refer to the instruction sheet or manual for the CCD camera.
Note:
• A power supply box (sold separately) is required for connection of the main unit and the CCD camera.
• The power supply box for the camera CAA185 cannot be used. Please use the CAA188 instead.
Notes on wire connection
When connecting the plugs and sleeves, be sure to insert the plug until it locks securely. After completing
connections, fasten the leads using lead clamps and tapes.
Connecting the reverse gear or parking brake signal lead
Connect each signal lead using the supplied electro-taps.
1. Place the lead from this unit at the stopper, and fold it back in the direction of the arrow.
2. Pass the vehicle signal lead through, and fold it back in the direction of the arrow.
Note:
• After connecting the parking brake signal lead, pull the parking brake and check that the line falls to ground.
• For your safety, some functions will not operate unless the parking brake signal lead is connected correctly.
Female
Sleeve
If the male knob is in the shape shown at
A,
cut the female sleeve about 5 mm.
Tape
Clamp
Male
Cut 5 mm.
Coupler connected to other equipment
From this unit
3. Electro-tap
Power supply lead from this unit
Power supply lead from this unit
Vehicle and main unit signal lead
Vehicle and main unit signal lead
Stopper