SONIQ M102 - Manual (Page 6)

5
Before connecting the power, check that the main voltage on the rating plate under
the radio is the same as the voltage in your area. Plug the AC power cord into the
wall socket and switch the main power on ,The unit is now ready for use.
The clock is set manually.
The clock displays the time in 24 hour format (for example,2a.m.is displayed as
2:00,2p.m.is displayed as 14:00). When setting the time or alarm, ensure that you
are setting times in this format.
1.Press the set button, the hour digits will flash.
2.Press the or button to set the hour digits to the correct time.
4.Now press the or button to set the minutes digits to the correct timer.
5.Press the set button again ,the clock is now set.
NOTE: If you prefer, you can hold down the or button when setting
the time. Then hour or minute setting will automatically change.
If a backup battery is fitted, the clock and alarm settings will be retained
in the event of a power cut.
3 . Press the set button again, the minute digit will flash.
Before using your clock radio for FM reception, unwrap and fully
extend the aerial wire. You may need to adjust the position of the
aerial wire for maximum signal strength.
1.Press the radio button, the radio will be switched on and the tuning frequency
will be displayed.
2.Press the radio button, the radio will be switched off.
3.Press and hold the or button for three seconds to search up or down the band
for a station.
4.Tuning will stop when the next station is reached and the station will play.
Adjust the aerial wire for the clearest reception.
5.Press the or button to tune up or down the band manually
in 0.1MHz steps.
6.Turn the volume control to set the volume you want.
SETTING THE CLOCK
LISTENING TO THE RADIO
Basic Operation
GETTING STARTED