SONIQ T200 - Manual (Page 10)

Symptom Possible Cause Remedy
LED on front panel
does not display. AC power cord
disconnected
Connect power cord
properly into the power
socket
Incorrect connection of the
video/audio output to TV
input terminal
Connect two terminals
correctly with RCA
Incorrect Connection of
antenna cable Connect the antenna
cable correctly
Incorrect placement of
antenna
No signal or weak signal
Your TV mode is
different from Set Top
Box broadcasting mode
Battery exhausted
Fluorescent light
interfering with the
remote controller
Power Down
Adjust the direction of
antenna
Check the cable
connections, TV and
other equipment
connected between the
TV and the receiver or
adjust the antenna
Use AV mode
Change the batteries
Switch off the light
Unplug the power from
the wall and plug it back in
No Power
The remote controller is
not working
Black and white screen
or V-Hold
No picture or sound
6. Troubleshooting
Troubleshooting
- 8 -