Sound Devices 722 - Manual (Page 68)

722 User Guide and Technical Information
66
v. 2.67 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
# Setup Name Setup Description Setup Options
79 EXHDD: Empty Trash Allows user to delete files previously sent to the trash
as well as false takes.
• Empty Trash
• Empty False Takes
• Empty both
80 Balance Cal Calibrates the center position of the input 2 pot when
used as the balance control for MS recording.
Place balance control to center and press to
select.
81 Power: Ext Low Batt Volt Sets the warning voltage of the low battery alert with
an external power source. Internal battery warning
threshold is factory set.
10.0–18.0 VDC, 0.1 V steps
82 Power: Ext Power Function Controls the behavior of the unit when power is ap-
plied to the external DC jack.
Pin-3 (+) of the external DC input must be wired in
order for the External Power Functions to operate.
• Do Nothing
• Power On Unit
• Power On and Start Record
• Power On/Off unit
• Power On/Off unit and Record
83 Power: Power-up Messages Enables or disables the notifications that appear upon
boot up (daily folder prompt, output attenuation notice,
and set time and date message). Disabling these
messages is useful when using the External Power
Functions to power on and start recording and the
Record Start and Stop Timer.
• Disabled
• Enabled
84 Ext Keyboard: Assign Enter to setup keyboard shortcuts when using the
CL-1 keyboard interface
85 Ext Keyboard: Language Select the language of the keyboard attached to the
CL-1.
• English
• German
• French
86 CL-1: Re-program The CL-1 has its own firmware which is supplied from
the 722. This utility updates the CL-1 firmware.
87 CL-1: Logic Out Assign Each logic output pin can be assigned to go high when
the unit is in the selected mode. Logic input overrides
logic output selection.
• Undefined
• Stop
• Play
• Pause
• Record
88 Info: Button Shortcuts An informative menu showing the available keyboard
shortcuts.
89 Info: Version Shows the hardware revision, serial number, and
firmware version of the unit.
90 Update Software Upgrade tool used to apply new firmware. It will search
all connected storage for the firmware file and prompt
to update.
Setup Menu Shortcuts
The Setup Menu can be quickly navigated using the Rotary Switch to move up and down through
the menu. Additionally, shortcuts, or “breadcrumbs” can be placed on often-used menu items. A
breadcrumb is set by holding the play button when at a selected menu item. A small dot is shown to
the left of the setup number. Any number of breadcrumbs can be set, but their utility is reduced with
too many applied.
toggles among menu bread
crumbs to higher numbered
items
with no bread crumbs placed,
moves to the next general menu
section
press and hold to set or remove a menu crumb; single
press navigates to menu item #1
toggles among menu bread
crumbs to lower numbered items
with no bread crumbs placed,
moves to a previous general
menu section