Tweco PAK 44G User Manual
Pak 44g
Advertising
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SECTION 2: INTRODUCTION & DESCRIPTION
- 2.01 Scope of Manual
- 2.02 General Description
- 2.03 Specifications & Design Features
- 2.04 Power Supply Options and Accessories
- SECTION 3: INSTALLATION PROCEDURES
- 3.01 Introduction
- 3.02 Site Selection
- 3.03 Unpacking
- 3.04 Removing Skid
- 3.05 Installation Of Optional Running Gear
- 3.06 Input Power Connections
- 3.07 Primary Voltage Selection
- 3.08 Primary Power Cable Connections
- 3.09 Work Cable And Ground Connections
- 3.10 Plasma and Secondary Gas Connections
- 3.11 Connecting Torch Leads
- 3.12 Filling Power Supply Coolant
- 3.13 Initial Start-Up Of System
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Functional Overview
- 4.03 Operating Control Descriptions
- 4.04 Getting Started
- 4.05 Gouging Operation
- SECTION 5: CUSTOMER/OPERATOR SERVICE
- 5.01 Introduction
- 5.02 General Power Supply Maintenance
- 5.03 Common Operating Faults
- 5.04 Troubleshooting Guide
- 5.05 Gas Pressure Regulators
- SECTION 6: PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Power Supply Remote Aera Spare Parts Kit
- 6.04 Power Supply Options and Accessories
- APPENDIX I: INPUT WIRING REQUIREMENTS
- APPENDIX II: SEQUENCE OF OPERATION BLOCK DIAGRAM
- APPENDIX III: TIMING CHART
- APPENDIX IV: SYSTEM BLOCK DIAGRAM
- APPENDIX V: RECOMMENDED ROUTINE MAINTENANCE SCHEDULE FOR WATER COOLED PLASMA CUTTING SYSTEMS
- APPENDIX VI: SYSTEM SCHEMATIC