Hygrometer functions, Using the sub-unit, Operation guide dqr-300 – Casio DQR-300 User Manual

Page 5

Advertising
background image

Operation Guide DQR-300

5

HYGROMETER FUNCTIONS

Both the main unit and the sub-unit are equipped with their own humidity sensors. Humidity data measured by the
sub-unit is sent by wireless transfer to the main unit. You can toggle the main unit display between the main unit
humidity reading and the sub-unit humidity reading. This makes it possible to view both the indoor and outdoor
humidity on the main unit display.

Humidity Measurements

•

Both the main unit and the sub-unit take humidity measurements every 16 seconds.

•

The humidity display shows “LO” for humidity below 10% and “HI” for humidity above 90%.

Switching between Main Unit and Sub-unit Humidity Data

•

Press the SELECT button (

B

) to toggle the display between the main unit (INDOOR) humidity and the sub-unit

(OUTDOOR) humidity .
Main unit humidity: INDOOR indicator displayed
Sub-unit humidity: OUTDOOR indicator displayed

•

The display does not change to the sub-unit (OUTDOOR) humidity if no data has been received from the sub-unit
yet.

•

Holding down SELECT button (

B

) for about two seconds causes the display to continually toggle between the

main unit and sub-unit humidity at five-second intervals.

Main unit

Sub-unit

SELECT button

(B)

INDOOR

OUTDOOR

High Humidity and Low Humidity Memory

•

The following data is stored in memory automatically.
Main unit high humidity and low humidity
Sub-unit high humidity and low humidity

•

To clear the high humidity and low humidity data memory, press the CLEAR button (

9

).

New data starts to be stored after memory is cleared.

USING THE SUB-UNIT

Data Transfer from the Sub-unit

•

Data is transferred from the sub-unit to the main unit every three minutes.

•

The sub-unit is able to send data to the main unit up to an unobstructed distance of about 30 meters.

•

The data receive status is indicated on the display of the main unit by the icons shown below.

Receive successful

Receive unsuccessful

•

If a receive operation is not successful for some reason, the display of the main unit shows dashes (–) in place of
the sub-unit temperature and humidity values.

•

If you experrience problems with data transfer, press the RE-SYNC button (

A

) to synchronize the two units.If

this does not eliminate the problem,try changing the positions or orientations of the main unit and sub-unit.

•

The transferred data includes temperature and humidity data.

Switching between Celsius and Fahrenheit

•

Push the

°

C/

°

F button (

F

) to toggle between Celsius (

°

C) and Fahrenheit (

°

F).

Celsius (

°

C)

Fahrenheit (

°

F)

°

C/

°

F button

(F)

Switching between Current Temperature and Humidity

•

Press the SELECT button (

C

) to toggle the display between the current temperature and current humidity.

•

Holding down SELECT button (

C

) for about two seconds causes the display to continually toggle between the

temperature and humidity at five-second intervals.

Temperature

Humidity

SELECT button

(C)

Location

•

Place the sub-unit in a location where it will not be exposed to rain, direct sunlight, or other elements.

Current temperature and humidity

MAX/MIN HUMIDITY button (

8

)

Main unit high humidity and low humidity

Sub-unit high humidity and low humidity

CLEAR button (

9

)

Advertising