Ultra-cut 200 xt – Tweco 200 XT Ultra-Cut Plasma Cutting System With Automated Gas Control User Manual
Page 45
Advertising
ULTRA-CUT 200 XT
Manual 0-5304
INSTALLATION
3-21
Preparation
1. Remove the screws securing the Cover Panel to the Module.
Loosen or remove 2 screws
Remove 2 Screws
Art # A-09139_AC
Cover Removal
2. Carefully remove the cover from the module noting the attached wire harness that connects to J1. Remove
the wire harness and then set the cover to the side.
Art # A-09140
Advertising