Fabricator 190 welding machine – Tweco 190 MIG Thermal Arc Fabricator User Manual
Page 28
FABRICATOR 190 WELDING MACHINE
INSTALLATION
3-6
Manual No. 0-4838
3.08 Attaching the Gun and Cable
Assembly to the Power Source
The Fabricator 190 is supplied with a Tweco Weldskill
gun 190 10217 air-cooled torch.
The Weldskill gun is
designed with an ergonomic handle and fewer parts to
cause performance problems. The Weldskill gun uses
standard readily available Tweco consumable parts.
1) Remove the door panel to the machine by inserting
your left and right index fingers into the two holes
marked with arrows in Figure 3-3 and firmly pull it
towards you.
2) Route the gun cable through the access hole in the
front panel. Refer to Figure 3-4.
3) Loosen the thumbscrew and insert the gun cable
end as far as it will go. Tighten thumbscrew. Refer
to Figure 3-5.
4) Insert the trigger plug into its receptacle and thread
its retainer on securely by hand.
NOTE
Lubricate the O-ring on the quick-connect
fitting with grease (Dow company #4
compound or equivalent).
4) To remove the gun, reverse these directions.
Art # A-07363
Figure 3-3: Door Panel Removal