Tweco 210 MIG Thermal Arc Fabricator - Manual (Page 35)

FABRICATOR 210
Manual No. 0-4855 3-13 INSTALLATION
3.15 Spool Gun Attachment
A spool gun can readily be used with the Fabricator 210 power supply.
1. Attach appropriate input gas to the Spool Gun input gas connection on the rear of the unit. (Refer to Figure. 3-
13)
2. Attach the Spool Gun control cable and gas hose to the 10 pin socket and the Spool Gun Gas Outlet on the
front of the unit. (Refer to Figure. 3-13)
Front Panel
Rear Panel
Spool Gun
Gas Input
Connection Main Gun
Gas Input
Connection
Spool Gun
10 Pin
Socket Spool Gun
Gas Outlet
Connection
Art # A-07345_AC
Figure 3-13 Spool Gun Connections
NOTE
When the SPOOL GUN is properly attached, Spool Gun/MIG Gun switch is set to Spool Gun and the trigger
is depressed, the internal wire feed and gas control are disabled and the SPOOL GUN feeder and gas
control operate.