Tweco Hefty II CC CV Voltage Sensing Wire feeder - Manual (Page 4)

INTRODUCTION
How To Use This Manual:
This Owner’s Manual usually applies to just the
underlined specification or part numbers listed on
the cover. If none are underlined, they are all cov-
ered by this manual.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular
attention to the information provided under these
headings. These special annotations are easily rec-
ognized as follows:
WARNING gives information re-
garding possible personal in-
jury. Warnings will be enclosed
in a box such as this.
CAUTION refers to possible equipment
damage. Cautions will be shown in bold
type.
NOTE offers helpful information concern-
ing certain operating procedures. Notes will
be shown in italics.
Equipment Identification:
The unit’s identification number (specification or
part number), model, and serial number usually
appear on a nameplate attached to the control
panel. In some cases, the nameplate may be at-
tached to the rear panel. Equipment which does not
have a control panel such as gun and cable assem-
blies is identified only by the specification or part
number printed on the shipping container. Record
these numbers for future reference.
Receipt Of Equipment:
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to shipping.
If there is any damage, notify the carrier immedi-
ately to file a claim. Furnish complete information
concerning damage claims or shipping errors to
Thermal Arc, Order Department, 2200 Corporate
Drive, Troy, Ohio 45373-1085. Include all equip-
ment identification numbers as described above
along with a full description of the parts in error.
Move the equipment to the installation site before
uncrating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-
crate the unit.
Additional copies of this manual may be pur-
chased by contacting Thermal Arc at the address
given above. Include the Owner’s Manual number
and equipment identification numbers.
430429-456
INTRODUCTION
November 17, 1999 1-1