Tweco FP-82 - Manual (Page 17)

Manual 0-2870 3-1 INSTALLATION
SECTION 3:
INSTALLATION
3.01 Introduction
This Section describes installation of the Power Supply
and connecting the Torch.
These instructions apply to the Power Supply only; in-
stallation procedures for the Torch, Options, and Acces-
sories are given in Manuals specifically provided for those
units.
Depending on how the system was ordered, some Power
Supply Options may already be installed.
If option(s) have been factory installed some of the in-
structions may not apply. It is recommended that all sub-
sections be read for general information.
The complete installation consists of:
1. Site selection
2. Unpacking
3. Connections to Power Supply
a. Input power
b. Gas
c. Torch Leads
d. Work cable
4. Grounding
5. Operator training
3.02 Site Selection
Select a clean, dry location with good ventilation and ad-
equate working space around all components.
Review Important Safety Precautions (Section 1) to be sure
that the selected location meets all safety requirements.
The power supply is fan cooled by air flow through the
side panel to the front and rear panels. Air flow must not
be obstructed. Provide at least 2 feet (61 cm) in the rear
and at least 6 inches (152 mm) on each side for clearance.
Provide a minimum of 6 inches (or 152 mm) clearance in
front of the unit to allow access to the front panel con-
trols.
CAUTION
Operation without proper air flow will inhibit
proper cooling and reduce duty cycle.
3.03 Unpacking
The product is packaged and protected to prevent dam-
age during shipping.
1. Unpack each item and remove any packing material.
2. Locate the packing list(s) and use the list(s) to iden-
tify and account for each item.
3. Inspect each item for possible shipping damage. If
damage is evident, contact your distributor and/or
shipping company before proceeding with the instal-
lation.
3.04 Lifting Options
This unit is equipped with a handle designed for hand
lifting only
. Be sure unit is lifted and transported safely
and securely.
• Only persons of adequate physical strength should
lift the unit.
• Lift unit by the handle, using two hands.
• Use hand cart or similar device of adequate capac-
ity to move unit.
• Place and secure unit on a proper skid before trans-
porting with a fork lift or other vehicle.
WARNINGS
Do not touch live electrical parts.
Disconnect input power conductors from de-ener-
gized supply line before moving unit.
FALLING EQUIPMENT can cause serious per-
sonal injury and equipment damage.
HANDLE is not for mechanical lifting.