Tweco Spool Gun Firepower User Manual
Page 10
Firepower
SPOOL GUN OPERATING AND SAFETY MANUAL
10
4. Installation
The manufacturer will not be responsible for damages caused by incorrect installation. Any
service required due to incorrect installation will not be covered by the warranty.
4.1. Connecting Spool Gun to the Power Source
The Spool Gun is provided with two connectors:
•
Connection for power cable, gas hose, liner, and trigger.
•
6 pin connector for motor power and wire speed control.
1. Before connecting the Spool Gun,
switch off the power source.
2. Connect spool gun Euro Connect
adapter to power source terminal and
rotate the lock ring clockwise until it is
firmly locked. (Do not over tighten)
3. Connect spool gun 6 pin connector to
power source terminal and rotate the
lock ring clockwise until it is firmly
locked. (Do not over tighten)
4. Once the connections have been made
properly, switch the power source on.
For more information please refer to spool
gun electric schematic (see page 19).
Figure 2
Figure 3