Unitec EZ Trak User Manual
Page 10
E Z T R A K
Document Number:
EZT1001
6
Figure 4. EZ Trak Terminal Base Dimensions
Warning:
DO NOT BEGIN MOUNTING OF THE TERMINAL UNTIL ALL WIRES & CABLES
HAVE BEEN PULLED THROUGH THE CONDUITS!
3.
Using the hammer drill, and the ½” inch concrete drill bit, drill the four
holes. Ensure that the holes are drilled deep enough to insert the anchor
bolts. A good depth is approximately 2”-2½” inches from the surface of
the concrete.
4.
It should be noted that while the anchor bolts are rugged and durable,
they could become damaged if struck recklessly. Care should be given to
strike only the top of the anchors, where the force will be distributed by the
provided area on top of the anchor bolt. Use the hammer to drive each of
the provided anchors into the drilled concrete holes.
Figure 5. Setting Anchor Bolts
Document Title:
EZ Trak Installation and Operations Manual