Ventamatic VX2515SOLAR GABL User Manual

Ventamatic Fans

Advertising
background image

©VENTAMATIC, LTD XXSOLARSTATSPEC 07/10

VENTAMATIC, LTD. P.O. BOX 728, MINERAL WELLS, TX 76068-0728 • PHONE 800-433-1626 FAX 940-325-9311 • HTTP://WWW.BVC.COM • E-MAIL: [email protected]

A leader in the ventilation industry for over 60 years, Ventamatic, Ltd. offers a complete line of air movement

products for commercial, industrial, agricultural, and residential use sold under these fine names:

Specification Sheet

Adjustable DC Thermostat

(XXSOLARSTAT)

Adjustable Thermostats for Solar- Powered Attic Ventilators

The Adjustable Thermostat (XXSOLRSTAT) for use with the above Models of

Solar-Powered Attic Ventilators is designed to turn the fan on and off

automatically.

THERMOSTAT SETTING
The thermostat setting governs the “fan off” temperature, i.e., the

temperature at which the fan turns OFF. When the temperature rises 15°

above the “fan off” temperature, the fan turns ON. As the temperature in

the attic is reduced, the fan turns off when the temperature in the attic

reaches the “fan off” thermostat setting.

The adjustable thermostat is pre-set at the factory at 90°. This setting is

user-adjustable. The setting that is best for your attic varies by

geographical location.

A setting that is too low will cause the fan to run constantly; a setting that is

too high will cause the attic to be over-heated since the fan will not turn on

until the temperature rises 15° above the “fan off” thermostat setting.

For Series Models: VX1000SOLAR, VX2515SOLAR GABL

WIRING DIAGRAM:

Connecting Solar Panel and Motor Wiring (Not to Scale)

Outside of XXSOLARSTAT

IMPORTANT! THE THERMOSTAT COVER MUST BE REMOVED IN ORDER TO PROPERLY WIRE THE THERMOSTAT. Failure to wire the

thermostat according to the diagram below will circumvent the thermostat entirely, and the fan will not turn off.

INSTALLATION

The thermostat should be installed in such a way that the thermostat

sensor, which is on the back of the control box, is not blocked. Usually, it is

best to choose a location where the control box can be suspended from

one of the rafters.

NEGATIVE (-)

SOLAR PANEL
18V DC

POSITIVE (+)

POSITIVE (+)

120

110

100

90

50

60

70

80

ADJUSTABLE

TEMPERATURE

THERMOSTAT

FAN OFF

TEMPERATURE

(15° DIFFERENTIAL)

CAUTION

Automatically started device –To reduce

the risk of injury disconnect from the

power supply before servicing. For

residentil use only. Se instructions for

wiring diagram.

Advertising
This manual is related to the following products: