Esc "v – CITIZEN iDP3410 User Manual
Page 112
iDP3410 User's Manual
98
CITIZEN
ESC "v"
[Function]
Sending the printer status
[Code]
<1B>H <76>H
[Outline]
This command sends the printer status.
[Caution]
This command is valid only for the serial interface. The following table lists the status
sent. In case of DTR/DSR control, only one byte will be sent after confirming that the
host is ready to receive (DSR signal has the Space status).
The status at command processing time is sent after processing the data received prior to
this command. If the printing is under way when the command is being processed,
however, the then status will be sent after completing print feed of that line. Therefore, it
may take time to send the status after receiving the command.
Value
Bit
Function
0
1
0
Paper near end
With paper
Near end
1
Undefined
2
Paper near end
With paper
End
3
Undefined
4
Undefined
0 stationary
−
5
Undefined
6
Undefined