CITIZEN iDP3410 - Manual (Page 45)

iDP3410 User's Manual
31 CITIZEN
11. DRAWER KICK-OUT CONNECTOR AND POWER CONNECTOR
11.1 Specifications of Drawer Kick-Out Connector
(1) Drawer kick-out drive signal
Parallel Interface ----- Can be learned at the no. 34 pin of the interface connector
Serial Interface ----- Provided with a command to learn the status in the Star and ESC/POS modes.
(2) Electrical characteristics
1) Drive voltage: 24 V DC
2) Drive current: 0.8 A at maximum(Within 510 ms)
3) Switch signal: Signal level
"L" = 0
∼
0.5 V
"H" = 3
∼
5 V
11.2 Connector's Pin Configuration
No. Signal Function
1 FG Frame Ground
2 DRAWER 1 Drawer 1 drive signal
3 DRSW Drawer switch input
4 VDR Drawer drive power
5 DRAWER 2 Drawer 2 drive signal
6 GND Common ground on the circuit
Connector used : TM5RJ3-66 (HIROSE)
Applicable connector : TM3P-66P (HIROSE) or equivalent
CAUTION :
•
No output is made while printing.
•
The drawers 1 and 2 cannot be driven simultaneously.
•
A solenoid used for the drawer should be of 36
Ω
or more. An output current should be
kept below 0.8 A. Use beyond this limit cannot be assured.
•
This connector cannot be connected to a telephone line. Do not connect other than the
solenoid.
11.3 Drive Circuit