Wheatheart Remote PowerSwing - Manual (Page 10)

2. A SSEMBLY W HEATHEART - R EMOTE P OWERSWING
2.2. H YDRAULIC C ONFIGURATION A232, A233, A234, A235, AND A236 MODELS
10 30664 R0
2.2. HYDRAULIC CONFIGURATION
This valve is designed to be used with
tractors / hydraulic pumps that operate
in open loop format or with CLLS
(Closed Loop Load Sensing) with sim-
ple modifications. If you are unsure of
your hydraulic configuration it is recom-
mended you contact your tractor dealer
to inquire. If you are unable to deter-
mine hydraulic pump configuration, we
recommend installing the valve in the
Open Loop configuration.
When shipped, the valve will be set-up
for Open Loop usage. Should you
require the valve set-up for CLLS,
follow these steps and refer to Figure
2.3.
1. Use two 7/16" wrenches to loosen
the two 1/4" bolts holding the valve
on.
2. Lift the valve, bolts, and spacers
from the mount as one, rotate it
180° as shown in Figure 2.3.
3. Insert the bolts into the second set of holes and retighten.
Figure 2.3
Note: There are 2 sets of holes into which to bolt the valve. When shipped, the valve
will be bolted through the holes closest to the end of the mount. When switching
to CLLS, you must use the other set of holes that are closer to the center of the
mount.
Note: When rotating the valve, the wires may become too short. If this occurs open the
junction box lid and slide extra wire out.
Figure 2.2