Wheatheart Remote PowerSwing - Manual (Page 11)

W HEATHEART - R EMOTE P OWERSWING 2. A SSEMBLY
A232, A233, A234, A235, AND A236 MODELS 2.3. A NTENNA P REPARATION
30664 R0 11
2.3. ANTENNA PREPARATION
When shipped, the antenna for the Remote Powerswing receiver will be within its
protective steel housing. The antenna must be positioned outside of the housing
(Figure 2.2) in order to get proper reception. Follow the steps below to adjust.
1. Use two 7/16" wrenches to unbolt the two 1/4" bolts holding the protective
receiver box onto the mount plate (see Figure 2.2).
2. Slide the receiver box off of the housing.
3. Use a hex head wrench and screwdriver to remove the four #10 x 3/4” bolts
securing the receiver to the housing bottom plate.
4. Turn the antenna downward and feed it through the appropriate hole in the
housing bottom plate.
Note: Section 6. Appendix on page 19 can be completed conveniently here.
5. Re-fasten the receiver to the bottom plate making sure to use the spacer
plates as they were installed before.
6. Slide the receiver box back on and bolt the assembly back to the mount.
Figure 2.4 Remote Powerswing Complete Assembly