Wheatheart Galvanized 4 Utility Auger - Manual (Page 9)

W HEATHEART - G RAIN A UGERS 2. S AFETY F IRST
4" G ALVANIZED U TILITY 2.2. A SSEMBLY S AFETY
30645 R0 9
• Follow good shop practices:
• keep service area clean and dry
• be sure electrical outlets and tools are properly
grounded
• use adequate light for the job at hand
• Think SAFETY! Work SAFELY!
2.2. ASSEMBLY SAFETY
• Read through the instructions to get to know the sub-assemblies and hard-
ware that make up the equipment.
• Do not take chances with safety. The components are large, heavy, and can
be hard to handle. Always use the proper tools, stands, jacks, and hoists for
the job.
• Always have 2 or more people assembling the equipment. Because of the
weight, do not attempt assembly alone.
2.3. OPERATION SAFETY
• Have another person nearby who can shut down the auger in case of acci-
dent. Always work with a second person around augers.
• Do not operate with any of the safety guards removed.
• Keep body, hair, and clothing away from moving parts. Stay away from intake
during operation.
• Augers are not insulated. Keep away from electrical lines. Electrocution can
occur without direct contact.
• Ensure that auger is empty before moving.
• Inspect auger supports on a daily basis.
• Support auger securely to prevent upending or upsetting.
2.4. MAINTENANCE SAFETY
• Shut down and lock out all power before attempting maintenance of any kind.
If applicable, disconnect PTO driveline from tractor or hydraulic hoses on
units with hydraulic drive hoppers.
• After maintenance is complete, replace and secure all safety guards and
safety devices, and if applicable, service doors and cleanout covers.
• Use only genuine Wheatheart replacement parts or equivalent. Replacement
parts such as intake guards, pulley guards, PTO driveline shields, winches,
and lift cables must meet ASAE standards or serious injury may result. Use of
unauthorized parts will void warranty. If in doubt, contact Wheatheart or your
Wheatheart dealer. Do not modify any auger components.
•