Great Plains Verti-Till Ripper VT 03 Hyddepth Convert - Manual (Page 2)

596-141M 11/29/2004
Great Plains Mfg., Inc.
VT 03 Hyddepth Convert to Mech
Update 2
Refer to Figure 2
3. Install the depth stop lower bumpers (1)
through the slot in the bottom of the torque
tube depth stop weldment (2). Orientate the
lower bumpers (1) so the taper is facing to-
wards the front of the implement. Allow the
lower bumpers (1) to slide to the front of the
channels in the torque tube depth stop weld-
ment (2).
4. Slide the depth stop lower bumpers (1) up and
down in their slots to check for binding. If bind-
ing occurs it will be necessary to remove the
bumper and sand or file to remove any paint
or burrs which may limit travel in the slot.
Refer to Figure 3
5. Place the flat filler bars (1) on the mounting
plates for the torque tube depth stop weld-
ment (2). Orientate the bars (1) with the holes
towards the top of the implement.
6. Place the torque tube depth stop weldment
(2) on the mounting plates trapping the flat
bars (1) in the slots where the lower bumps
were installed in step 3 above.
7. Fasten the torque tube depth stop weldment
(2) to the mounting plates using the hardware
removed in step 2 on page one.
Figure 2
Depth Stop Lower Bumper
22801
Figure 3
Flat Bar
22802