Great Plains Terra-Tine Row Cleaner - Manual (Page 12)

Terra-Tine™
207-016M 5/2/2005
10
Note: All adjustments must be made
with the unit in the full raised position.
Refer to Figure 6
1. Set the height of tine fingers flush with the
bottom of coulter blade when the blade is out
of the soil by adjusting the lock collar height.
2. Side-to-side alignment can be done by
rotating the shank mount around the vertical
shaft and retightening the square head set
screw.
!
CAUTION
Be sure to check that the Terra-Tine™ Row Cleaner
tines DO NOT touch the coulter blade or any other at-
tachments. Such contacts will cause excess wear to all
parts involved. At least 1/2 inch clearance is recom-
mended.
3. Fore-to-aft adjustment is accomplished by
adding or removing the extension arm
(number 4 in figure 1 on the previous page) to
place the Terra-Tine™ Row Cleaner to either
side of the coulter hub depending on the
desired position or clearance between other
attachments. Testing has shown better
performance behind the hub, however,
available space may dictate the mounting
position.
Adjustments
R.H. in front of
the hub
L.H. in front of
the hub
L.H. in behind
the hub
R.H. in behind
the hub
Figure 6 13469