Assembly – Great Plains Eliminator Kit User Manual
Page 2
Advertising
404-114M
2/13/2006
Great Plains Mfg., Inc.
2
Assembly
1.
Remove side-gauge-wheel arm and side
gauge wheel from row unit.
Refer to Figure 1
2.
Remove side-gauge-wheel arm from side
gauge wheel. Discard arm and replace with
new arm provided in kit.
Set Screw Wheel Arms: Secure new arm to
wheel with set screw and jam nut provided in kit.
Refer to Figure 2
All Other Kits: Secure new arm to wheel with ex-
isting bolt. If necessary, place one or two shim
washers between wheel and arm. When assem-
bled, the wheel should turn freely and not hit the
arm at its curve.
Refer to Figure 3
3.
Install eccentric bushing inside housing.
Figure 1
Side-Gauge-Wheel Arm
17908
Figure 2
Existing Bolt
17907
Figure 3
Eccentric Bushing
17909
Advertising