Adjust walkboard, Remove walkboard extension, Move walkboard back 4 – Great Plains Yield-Pro Planters Refuge Hopper Kit User Manual
Page 4: Inches
4
Great Plains Manufacturing, Inc.
YP Refuge Hopper Kit
403-287M
05/11/2011
Adjust Walkboard
Remove Walkboard Extension
Note: This applies to all planters except the YP2425
and YP2425A which have dual hoppers and the
walkboard is not located at the rear.
13. Walkboard should still be swung out to side.
14. It is necessary to make room to fit the refuge hop-
per on the planter.
Using a torch cut off the smaller walkboard exten-
sion piece. (You will be cutting through the bracket
that is welded to the bottom of both walkboard sec-
tions).
15. It is recommended to use a grinder to smooth the
edges. Spray with aerosol spray paint to prevent
rusting.
Null4:
Move Walkboard Back 4
3
⁄
4
inches
16. To allow room for the refuge hopper, move the walk-
board mount back 4
3
⁄
4
inches to back set of
prepunched holes on the frame. Attach with existing
hardware.
Figure 4
Walkboard Extension
13128
Figure 5
Walkboard Set Back
31331