Great Plains Fertilizer Arm Kits - Manual (Page 8)

204-326M 7/31/2002
6
Assembly for Great Plains and
Utility Coulter
Refer to Figure 1
1. Bolt the tine extension arm (1) to the coulter
swing arm using backing plate (2), carriage
bolts (3), flat washer (4), lock washers (5) and
hex nut (6). Do not tighten at this time.
2. Bolt the spring tine to the inside of the tine
arm in the desired hole for your desired depth.
This adjustment can be made either by sliding
the tine arm up or down the coulter swing arm
or remounting the spring tine in another hole
in the tine arm.
3. With the tine set at the desired depth and an-
gle, tighten all hardware.
Assembly for Yetter Coulter
Refer to Figure 2
1. Remove knife assembly by removing the
coulter hub bolt and bolt directly above it.
Take care to save the bushings and the fas-
teners for future use in assembly.
2. Using the fasteners and bushings from step 1,
assemble the adjustment plate (2) and the
hold down plate (1) onto the coulter linkage.
Do not tighten at this point.
3. Assemble the spring tine parts as shown. Do
not tighten adjustment bolt at this time.
4. Adjust plate (2) so that the spring tine is near-
ly vertical. Set spring tine as shown below.
Tighten all bolts.
Figure 1
Great Plains and Utility Coulter
Figure 2
Yetter Coulter
20169
20168